Portable Power Stations

Portable Power Stations are the next big thing, with brands like EcoFlow, Laser NRGVAULT, BLUETTI, Anker Powerhouse and many more vying for your custom. But we discovered that buying the right one for your needs is far more complex than imagined.

At their most basic, portable power stations are just a big rechargeable battery bank. Charge, and it converts that to a mix of 240V AC and 5 to 20V DC.

Campers, caravan/motor homes, tradies (on-site), boat owners, medical equipment users (CPAP), unreliable mains power supply (blackouts), and anyone that wants portable power without using a fuel-powered generator. Unfortunately, they are a bit too small at present for EV owners’ emergency on-road top-ups – watch this space.

Here is what to look for in portable power stations. Note images used are from the companies above and do not imply endorsement until reviewed.

For example, a radiant bar heater uses 240V AC x 10A = 2400W (the maximum a household circuit breaker can handle). A laptop may use 20V DC x 3A = 60W.

If you are interested in how Amps kill, read this.

Next is AC and DC power. Batteries can only store DC power (direct current) and use an inverter to make AC (alternating current).

Think of this as litres of fuel in the tank. We all know fuel economy depends on the car's load, speed, and braking. The bigger the capacity, the more devices it can run for longer.

You may have to look to find these figures because most portable power stations advertise Inverter capacity. The higher the Wh, the more it can support.

Think of this as how much horsepower you need – if you tow a caravan, you need more power.

The inverter takes the battery's stored DC power and turns it into AC power. For example, it may have a 1000W inverter. That means the total wattage you can support is 1000W, but inverter technology varies and may not sustain 1000W (what we call Peak Wattage).

There are at least two types of inverters. The cheap ones are square wave (sometimes called Modified Sine Wave). Fridges, jugs, power tools etc., can use square wave. But the better and more costly ones are pure sine wave (smooth). Any electronic (IT) equipment needs a sine wave, so make sure you buy this.

We also need to factor into account inverter efficiency. The majority will be at most 85% efficient at converting DC into AC, so assume that quoted Wh is about 15% higher than reality.

Think of this as the top speed the car can reliably reach and stay at. It may be capable of 200kph for short bursts but can only reliably do 100kph all day.

When you turn on a fridge, it may jump to 2400W (maximum) as the compressor starts. After that, it may settle back to 500-700W.

In this case, you need an inverter to handle a 2400W peak load. Or if you have several devices attached, it must take their peak loads simultaneously.

Think of this as seats in a car – bucket, bench, baby seat etc. There is no use in buying a two-seat sports car if you need five seats etc. Some portable power stations have many AC and/or DC ports, but you must ensure the peak and sustained loads are not exceeded regardless of port numbers.

For example, if it has four x 1500W ports but only a 1500W inverter, the maximum load across all four ports is 1500W. Don't think you can plug in a power board for more outlets!

DC is much more forgiving as USB-A and USB-C ports have power standards. USB-A are generally 5V/1 or 2A/5 or 10W but some may also have 5V/3A/15V and 9V/2A/18W (called QC 2.0 or 3.0).

USB-C usually is 5V/3A/15W, but some may have PD (Power delivery) as high as 20V/5A/100W.

If you use it for USB electronic devices like notebooks or smartphones, look for PD/PPS/QC compatible ports charging to at least 20V/3A/60W (typical laptop).

Lithium-Ion (Li-Ion), Lithium-polymer (Li-Po), Lithium Iron Phosphate (LiFePO4 or LFP), lead-acid (like a car battery), Nickle cadmium (NiCad), and even rechargeable Alkaline batteries. Inside will be dozens to hundreds of individual batteries.

Charge cycles are the times you can recharge from 0-100%, and one cycle equals two half cycles etc. The lower-cost units may have as few as 300 charge cycles, whereas the better ones may have 3000+. Once reached, the batteries may only hold 80% of a full charge (normal).

Portable power stations lose energy when not in use. You must top them up every few months to preserve battery charge cycles. So if you only plan on using it occasionally, set a reminder in your calendar.

Remember, the more Wh, the more batteries and more weight. The operative word is portable, so figure on smaller ones at <10kg and larger ones from 15-30kg.

All will have a 240V charge port (240V electricity is a maximum of 2400W). Most will charge at 240V/5A/1000W so as not to overload a power circuit. Charge times depend on the capacity, and as a rule of thumb, if you have a 1500Wh unit, it will take at least 1.5 hours (1500/1000=1.5 hours). Of course, some recharging energy is lost to heat, so it is safe to assume it may take a little longer.

Some have a vehicle charging port. Most cars have a 12V socket (varies between 13.5-15V when running) and can output 10A (some are rated to 20A – check the fuse rating), giving 135W. Using the formula 1500Wh/135W=11.11 hours at least of charge time. If you plan to use the car regularly to charge it, an auto electrician can tell you the maximum Volt/Amp port they can install. Tradies often have a 12-30V/7A/200W port fitted, bringing charging time back to 7.5 hours.

Solar is another source. Depending on the panel types (usually folding to fit in a car or van) and with the wattage they can produce during sunlight hours, you may be able to charge at up to 300W. That means a 1500W battery could be charged in 5 hours, although solar has a lower energy density and greater conversion loss.

Electricity and water do not mix. If you intend to use this outdoors, you will need an IP rating of at least IP67 and some outlet protection to stop water from getting onto the plugs.

All Lithium-based batteries present a fire risk, especially if mishandled. While minimal, as a precaution, you should only charge them in an open space (like a garage).

It should have an electronic battery management system covering protection for Under/Over Voltage, Over Current, Short Circuit, Overcharging Voltage, Over Temperature and Overload.

Some also have a Residual Current Circuit Breaker (RCCB) and or Ground Fault Circuit Interrupter (GFCI) that senses current and disengages any voltage circuit whenever a fault occurs.

If not, invest in an HPM Electresafe Power Centre with two USB outlets REPC410USB (review).

Some have Qi Charge pads, NFC, smartphone Apps and more. As long as the unit has a readout of remaining Wh, port loads, and charge status, these things are not the reason to buy.

If the device is heavy, look for integrated handles and wheels (like a suitcase).

Some offer UPS (uninterruptable power supply) mode that can take over when mains power goes down. These need to be hooked into a special circuit and only support the recommended peak load of devices on that circuit. Look for switch-over rates of well below 20ms.

Some brands offer various accessories like solar panels, charge cables and in-home ecosystem connection options.

Some offer battery expansion packs. If you think you will need power (Wh) for longer, these are a good idea but remember that the inverter has a fixed Amperage.

We strongly suggest you don't buy any unit with less than two years warranty; the longer, the better.

Look for well-known brands with Australian offices, warehousing, and service facilities. Remember that these are heavy units, and you may be up for a lot of money to freight them back if needed for warranty. Look for those that cover freight both ways if the unit is faulty. Most will replace a faulty unit with a refurbished one with the balance of your new warranty.

Buying from a recognised retailer like Harvey Norman or recognised camping and recreational outlets with good customer service and return policies is safest. All will be made in China – no alternatives.

Brands to look for include NRGVAULT, Ecoflow, Bluetti and Anker PowerHouse.

What do you do at the end of its life? Is the whole unit recyclable or disposable? Most portable power stations will use 32700 size, 3.2V, 6000mAh batteries (or similar). A 500W unit uses about 16-20, and a 1500W about 65-70. The individual batteries are available for under $10 each. Currently, no maker has a battery replacement policy, but several battery repacking companies claim to be able to replace cells (you must replace all cells).

As a guide, the cost per watt/hour Wh at 240V (not DC Wh) is a good start. Leaving aside brands and technologies, the usual price per Wh varies from $2-4 (larger banks have lower per Wh). Don't calculate using Ah or confuse this with the advertised inverter Wattage capacity.

Then you can look at power cycles. If a unit has 3000 power cycles and costs $1000, that is 33 cents (plus electricity) per charge. If the same unit has 500 power cycles, that is $2 per charge.

Portable power stations are only a short-term substitute for a generator (which runs on petrol, diesel, or gas), although it is relatively silent (it may have a fan for cooling). This means it is safe to use indoors out of the weather.

Chris Lau, Managing Director of Laser NRGVault, contributed to and fact-checked this guide. Chris's strongest advice is to seek out portable power stations with LiFEPO4. He states:

In our testing, LiFEPO4, compared to Li-Ion, is far safer, has more charge cycles (we’re quoting 5K+ on some units), and is less toxic (can be recycled). We also see much higher charge retention rates (up to 90% still in the battery after six months of no use). LiFEPO4 does not heat up. We have had multiple devices drawing a lot of power in bright sunlight, and the fan doesn't even come on. Lastly, they can be left connected to a charging source (pass-through charge and power), so it kicks in like a UPS (they call it EPS – emergency power supply). Think fridge, CPAP or router/modem, etc. In a blackout, connected devices keep going. There will be a flood of generic Portable Power Stations coming from overseas (if CES 2023 was anything to go by), so it is good advice to stay with the trusted brands.

With your permission, we’d like to share the guide with the store network as part of our product training.